Well, having my new darkroom, a new (to me) CPA-2 with a 3005 drum, a batch of Agfa "Process 44" that officially expired 2 weeks ago (no, the bottles WEREN'T full - I know, I know! ), and a brand new box of E100G, I could't resist doing some 8x10s yesterday and see what the Kodak E100G looks like. I ran some Fugi Provia when the chemistry was fresh and they were ok but lacked the colour saturation that I liked in the 4x5 Kodak E100G. The 8x10s look good on the light table but, when you hold them just right, there is a bluish haze on the back of the sheet. I presume this is the anti-halation layer, though I have never seen it before. If it is, then I have two questions: #1 - Would the anti-halation layer be left because of the age of the chemistry or for some other reason? (I didn't get this on the Provia when the chemistry was fresh and it was developed in the same tank.) #2 - How can I remove the anti-halation layer "post-processing" without damaging my transparencies? (If it is possible at all.) Thanks gang!