Cheapskates Polaroid 4x5 55 film test

Discussion in 'B&W: Film, Paper, Chemistry' started by esearing, Dec 21, 2004.

  1. esearing

    esearing Subscriber

    Messages:
    143
    Joined:
    Aug 17, 2004
    Location:
    Northern sub
    Shooter:
    4x5 Format
    I've gotten so cheap I have figured out a way to reduce my exposures when using Polaroid 55 in tricky lighting or uncertain situations. This may not be new but I haven't seen it posted elsewhere.

    Lets assume your light meter indicates an incident reading of 1/2 second at a chosen fstop rated for a print at ISO 50. For some reason you don't trust it and want to test to be sure. Below are two possible quick tests.

    A) Assuming you think it might be under exposing your film: You will want to see -1 stop to +1 stop. Insert the film in the holder as normal and pull the envelope out as normal, then mark 1 inch intervals from the holder to the edge of the envelope. Change your shutter speed to 1 stop below your meter reading, in our example 1/4sec. Make an exposure. then slide the envelope to the first mark, and make another 1/4 sec exposure. Repeat this for 4 exposures. When you are done and process the print, you will have -1, 0 (meter), +1/2 and +1 stop exposures from your meter. (1/4 = -1, 2x1/4= Meter, 3x1/4=+1/2, 4x1/4= +1stop). Pick the best frame and use that for your final exposure. If the ideal stop is somewhere between two exposures then adjust your fstop accordingly.

    B) Assuming you think you would prefer less exposure than your meter use 2 stops faster shutter (1/8th) and do the same 4 exposures as above. That will give you -2, -1, -1/2, and 0stop exposures to compare.
    IF you do 6 exposures you can get +1/4th stop and +1/2 stop as well.

    Notes: You can also use the exposure test before exposing your favorite film. Be sure to adjust for film speed differences. There may be slight differences in cumulative vs actual shutter speeds; two 1/4th sec exposures may not equal 1/2 second. Your shutter would need to be tested for this.

    this may work with pack film backs too if you can move the darkslide back and forth.
     
  2. rbarker

    rbarker Member

    Messages:
    2,222
    Joined:
    Oct 31, 2004
    Location:
    Rio Rancho,
    Shooter:
    Multi Format
    In-camera test strips. Love it.

    I've done something similar a couple of times, but with normal exposure on the majority of the film, and no exposure on the balance. :wink:
     
  3. L Gebhardt

    L Gebhardt Subscriber

    Messages:
    1,769
    Joined:
    Jun 27, 2003
    Location:
    NH
    Shooter:
    Large Format
    Good idea. I wonder if reciprocity failure would come into effect given you have spread your exposures out.
     
  4. esearing

    esearing Subscriber

    Messages:
    143
    Joined:
    Aug 17, 2004
    Location:
    Northern sub
    Shooter:
    4x5 Format
    Reciprocity? Maybe if the cumluative exposures were more than a few seconds. You are more likely to have image movement due to the multiple exposures, so it may not work for "busy" images, but could be used to evaluate sky or smoother areas.

    Figured out another method but have yet to try it. Assume you want to test exposures between 1/2 second and 1 second in 1/4th stop increments. Using similar method as above with sliding the envelope or darkslide make the following exposures:

    1) 1/2th sec (this is meter at 1/2 sec), move slide
    2) 1/8th sec (set shutter 2 stops faster) move slide Now at +1/4th stop
    3) 1/8th sec move slide Now at +1/2th stop
    4) 1/8th sec move slide Now at +3/4th stop
    5) 1/8th sec Now at +1 stop

    Lets assume the 3rd exposure (meter + 1/2stop) was the "best". Set your shutter at 1/2 sec and then move the f-stop 1/2 stop slower (more light). If DOF is of concern then set shutter at 1sec and move the f-stop -1/2.