Separate names with a comma.
Discussion in 'B&W: Film, Paper, Chemistry' started by tim atherton, Nov 4, 2005.
(not pyro ) - any other recommendations for developers for PL100 sheets?
I used Acufine at ASA 250 and times from the MDC.
Rodinal 1:50 10 mins. 1 minute presoak straight from J and C site.
Look here Efke Developing Times
thanks - I was looking at the efke 100 tech sheet on the J&C site and had missed that chartI'd missed
I've used Rodinol and had decent, but grainy, results. There is always D-76, which gives good results with just about anything.
I've done kb100 in Xtol stock with very nice results. Today I'm going out with several holders of pl100 and I think I will try that again.
I was pleased with the results I got using HC-110, dilution B.
(...but more pleased with the results from Pyrocat-HD!)
I answered over on the LF forum, but in addition, these shots are all Efke PL100 4x5", EI 200, Acufine 4 min. at 68 deg. F, agitating every 30 sec. in a Nikor tank. Click on the image to cycle through about half a dozen shots--
Beutler's, 10 min, or Rodinal 1+24, 8 min. Both on a JOBO CPE. 5x7" negs are just great, but I'm beginning to consider cutting the development back by a little bit.