FS: 5x7 Agfa Ansco $250

Discussion in '[Classifieds] For Sale' started by Kevin Kehler, Jul 7, 2012.

Thread Status:
Not open for further replies.
  1. Kevin Kehler

    Kevin Kehler Member

    Messages:
    605
    Joined:
    May 14, 2008
    Location:
    Regina Canad
    Shooter:
    Medium Format
    I bought this in the Spring to complement my other 5x7 Agfa Ansco but don't see the need for two cameras that are the same plus I don't have the time to strip/stain/rebuild.

    The bad:
    • The camera has been repainted by a previous owner (you can see the original paint in places) and they didn't do a great job as there are a couple of runs in the paint and you can see the brush strokes. It is also gun-metal grey which was supposedly the more expensive option in 1941.
    • The flash light test reveals 4-5 pin holes in the bellows. I was actually surprised at how few holes there were and how small they are - I think they could be fixed with a little tape or by throwing a dark cloth over the bellows during shooting but I leave that up to you. I included pictures of both sides of the bellows but most of the rubbed areas hasn't produced a pin hole yet.
    • No lens boards included (I only have 2 and need both). However, they have the same measurements as B&J boards (5.25x5.25 at 3/16 thick) but I have not tested those boards.
    The good:
    • Camera has front rise, front shift, front tilt, back swing and back tilt.
    • Bellows extend about 17" and are very supple, with no kinks or significant sagging.
    • All original bakelite knobs and hardware intact plus all the serial numbers match.
    • Extension rail works nice, locks well and camera folds up to 6-7" wide.
    • I have a cherry version which is in pristine condition and this one works as well as that one but I like the natural wood finish more. I was going to make this a project camera to restore more fully but don't have the time
    Price is $250 for the camera alone or $300 for camera, packard shutter (untested but could be used as the basis for a lens board) and 2 modern 5x7 Lisco Regal holders. Paypal preferred (I will pay the fees) or money order. Shipping not included in the price but I would expect it to be $40-50 from Canada to the USA due to the weight; will ship internationally but would probably be very expensive. All shipments must include tracking, insurance and an accurate price on the customs form. 7-day inspection period but buyer pays shipping both ways.

    If you think my price is way off, make an offer - also looking for a 35mm 1.8 DX for Nikon, 140mm macro RZ lens or 120-180mm large-format lens that will cover 5x7 in a modern copal shutter. 5% to APUG.
     

    Attached Files:

  2. rjs003

    rjs003 Member

    Messages:
    264
    Joined:
    Feb 4, 2004
    Location:
    Finger Lakes
    Shooter:
    Large Format
    PM sent
     
  3. Kevin Kehler

    Kevin Kehler Member

    Messages:
    605
    Joined:
    May 14, 2008
    Location:
    Regina Canad
    Shooter:
    Medium Format
    Sold pending payment.
     
Thread Status:
Not open for further replies.