FS: Packard Shutter and Bulb $29 - for repair

Discussion in '[Classifieds] For Sale' started by Jon Shiu, Oct 16, 2012.

Thread Status:
Not open for further replies.
  1. Jon Shiu

    Jon Shiu Subscriber

    Messages:
    2,822
    Joined:
    Dec 2, 2003
    Location:
    Elk, Califor
    Shooter:
    Plastic Cameras
    SOLD

    Packard Shutter with 2 3/4" or 69mm hole. Overall width is about 5 1/8".

    The shutter works, but because the bottom of the case has been cut off (C), the blades can get jammed. If one were to put a stop, strip of wood, on the lens board to keep the blades from moving down too far, it would work fine. See pictures, where at point (A,) it can get too low and locked up against the screw post.

    Additionally, I glued some cracks in the blades and a piece of aluminum where the notch (B) part broke off. The instant, "pin" mode doesn't work.

    Includes bulb and tube. I don't have any use for this, but hope someone can make use of it.

    $29 plus postage. Paypal accepted.
    pack2.jpg
    pack1.jpg
    pack3.jpg
     
    Last edited by a moderator: Oct 16, 2012
Thread Status:
Not open for further replies.