Help! Jobo ATL 2 question and instruction manual search

Discussion in 'Darkroom Equipment' started by DrPhil, Apr 4, 2004.

  1. DrPhil

    DrPhil Member

    Messages:
    169
    Joined:
    Dec 12, 2003
    Location:
    Indiana
    Shooter:
    4x5 Format
    I just found an upgrade for my Jobo CPA processor. IT's a Jobo ATL 2. However, I'm having a few issues getting it working correctly. It starts and runs just fine. But, I'd love a manual so I could figure out how to program the thing. Does anyone have one they could send me? Jobo has pdfs for some of their processors online. Just not for the ATL2.
     
  2. John Sparks

    John Sparks Member

    Messages:
    20
    Joined:
    Sep 13, 2003
    Location:
    Colorado
    I have a manual somewhere that I could xerox, it's about 45 pages. Send me an address and I'll mail you a copy.
     
  3. Garry williams

    Garry williams Member

    Messages:
    2
    Joined:
    Sep 18, 2004
    Shooter:
    35mm
    Please Please can I have a copy

    I got this unit today and cannot find a manual anywhere even at jobo's site
    Thanks
    Garry
     
  4. Thilo Schmid

    Thilo Schmid Member

    Messages:
    357
    Joined:
    Sep 10, 2002
    Location:
    France
    Shooter:
    Multi Format
    I do have an ATL2 as well as a manual, but that is german only. Programming the ATL2 quite easy.
    1. select a program number
    2. turn the dial from "run" to "set"
    3. press "reset"
    4. enter the amount of chemistry (in liters at least for european versions) or press "set full" to select max.
    5. press arrow down to set the temperature
    6. press arrow down to select the time for each program step according to the LED on the step list. First time is warm up, second pre wash, third first chemistry, forth 1. Wash...etc
    7. press reset again
    8. turn dial to "run"
    9. press start to start the sequence.
    10. press start again to commit amount of fluid (according to the dial)
    11. the program starts as soon as the temperature is ok. The "temp" light is flashing otherwise. You may select manual+fluid temperature to override and start at any temperature.