JOBO dev with ID 11...

Discussion in 'B&W: Film, Paper, Chemistry' started by ambrogea, Aug 16, 2012.

  1. ambrogea

    ambrogea Member

    Messages:
    1
    Joined:
    Apr 21, 2011
    Location:
    texas
    Shooter:
    Medium Format
    Hi all,
    i might target a small group there, but does anyone have background or tried development on jobo with id 11?
    especially regarding temperature change to minimize dev times... mainly concern about the grain.
    i'm focusing on fp4 at the momment.
    cheers
     
  2. CatLABS

    CatLABS Subscriber

    Messages:
    1,473
    Joined:
    May 20, 2011
    Location:
    MA, USA
    Shooter:
    Large Format
    Can you ever go wrong with ID11?

    on the other hand FP4 is always wrong :wink:.s
     
  3. Keith Tapscott.

    Keith Tapscott. Member

    Messages:
    1,426
    Joined:
    Jun 11, 2005
    Location:
    Plymouth. UK
    Shooter:
    Multi Format
    For D-76 diluted 1+1, my time for FP4 Plus in a Jobo CPA2 with the Jobo lift is 9':45" at 20*C (without a pre-rinse). The time with , ID-11 should be very similar. Increase the time if the contrast is not enough or reduce if it is too much.
    In some of the Kodak publications, the times given for rotary tube processing is the same as the small-tank times for inversion agitation, so you will need to experiment.
     
    Last edited by a moderator: Aug 17, 2012
  4. Neal

    Neal Subscriber

    Messages:
    1,618
    Joined:
    Dec 3, 2004
    Location:
    Chicago, Wes
    Shooter:
    Multi Format
    Dear ambrogea,

    Good news! The developing time for FP4+ in ID11 stock at 68°F is going to end in the 7:15 range. There is no reason to raise the temperature as you will save little time.

    Have fun,

    Neal Wydra