Kodak K SeriesThermometers

Discussion in 'Darkroom Equipment' started by gleaf, Dec 30, 2012.

  1. gleaf

    gleaf Subscriber

    Messages:
    270
    Joined:
    Dec 9, 2012
    Location:
    Kentucky
    Shooter:
    Large Format
    Photo's I see if the K-3 show a dual scale (F and C) etched glass thermometer in the stainless guard.
    Discovered a similar appearing thermometer with Fahrenheit only etched scale...
    along with two guards without thermometer glass.

    Were the K's partial or full immersion thermometers?
    Did Kodak make their own Hg in glass tubes?

    If no, does anyone know of the actual manufacturer?
    Is there source for replacement glass, either spirit in glass or Hg in glass to the K series accuracy?.

    What I am finding in the laboratory thermometer suppliers (NIST and ASTM rated) liquid in glass units are not in the
    scale range of the K-3. More or less range but in the 300 - 305 mm (12 in) length arena.

    Hate to see two nice stainless guards go to waste.


    Best

    George
     
  2. Ken Nadvornick

    Ken Nadvornick Member

    Messages:
    5,004
    Joined:
    Mar 18, 2005
    Location:
    Monroe, WA, USA
    Shooter:
    Multi Format
    I purchased a Kodak Type 3 mercury thermometer (dual scale range to 140F/60C) in the stainless sheath from a very nice fellow APUG member. Sounds like what you are describing. Mine does show the immersion calibration mark etched into the glass.

    When I got it I removed the glass, cleaned and polished until it looked new, then reset the glass. It's a beautiful instrument. It now serves as my darkroom standard. All of my other units have been calibrated to it, including a Hass Intellifaucet and the temperature compensation curve of my Zone VI Compensating Developing Timer.

    If you should decide you don't want one or both of those stainless guards, or the other Fahrenheit-only thermometer, please send me a PM (Private Message) as I'd take them off your hands for a fair price.

    Oh, and welcome to APUG, George...

    :smile:

    Ken
     
    Last edited by a moderator: Dec 30, 2012