I have been getting corner delamination on some RC contact sheets I made last month. Since I am planning to use RC paper for the prints in the near future, I thought I'd investigate why. I use Ilford paper exclusively. I read in Ilford's RC paper fact sheet that Ilford does not recommend wet times longer than 15 minutes for their RC paper. Problem is, I use a college darkroom and usually do not do a wash until the end of the period, which is about two to three hours later. During that time, the prints sit in a holding tray with running water. Is there a way around this relatively short wet time or I just have to put up with washing and drying the prints as they get out of the fixer?