What is this

Discussion in 'B&W: Film, Paper, Chemistry' started by lifthard1, Feb 17, 2013.

  1. lifthard1

    lifthard1 Member

    Messages:
    216
    Joined:
    Mar 9, 2011
    Location:
    Alabama
    Shooter:
    35mm RF
    I purchased a hassy 500cm and this is the first roll that I ran .What is the lines going through the negs. Ty for your help

    [​IMG]
    xtol008 by lifthard1, on Flickr
     
  2. chriscrawfordphoto

    chriscrawfordphoto Member

    Messages:
    1,178
    Joined:
    Mar 12, 2007
    Location:
    Fort Wayne,
    Shooter:
    Medium Format
    Scratches. A roller in the film back in dirty and probably not turning as the film moves over it.
     
  3. jeffreyg

    jeffreyg Subscriber

    Messages:
    1,378
    Joined:
    Jun 12, 2008
    Location:
    florida
    Shooter:
    Medium Format
    There appears to be a lot of dust and a large scratch in the emulsion. I am assuming this is a scan of an unexposed part of the negative that has not been reversed. Those would be caused by improper handling of the film perhaps while it was still wet. If it is a positive representation then they would be black. It appears to me that the even spacing and straightness of the lines could possibly be from your scanner. I've used Hasselblads for many years and have not run into anything like what you have shown. Can you see them on the film? If it is an unexposed part of the film in the negative -- maybe some static electric issue? Maybe someone more knowledgeable than me will chime in.

    http://www.jeffreyglasser.com/
     
  4. lifthard1

    lifthard1 Member

    Messages:
    216
    Joined:
    Mar 9, 2011
    Location:
    Alabama
    Shooter:
    35mm RF
    You were correct it was in the scanner.
    TY so much