PDA

View Full Version : Washing Ilford MGIV RC PEARL



Kycoo
01-09-2013, 12:30 PM
I have never experienced delamination with Ilford RC the paper the 3 years I have been using them. However, I read somewhere (don't remember where) that it is not recommended to keep RC paper wet time longer than 15 minutes or so. The question is, what is the proper "workflow" when using RC paper, especially when it comes to washing?

Currently, I do not wash RC paper individually; I wait until the end of the printing session (I use a public darkroom) and wash all of my prints at the same time for 5 minutes. This means my prints may be in the water holding tray for about 2 hours, sometimes longer! Like I said, never had a problem but I sometimes see very small edge delamination. To follow the correct procedure, should I be washing an RC print as soon as it comes out of the fixer, i.e., individually for 5 minutes at a time?

----Pat

R.Gould
01-09-2013, 01:01 PM
For RC paper I have a home made washer, simply a cat litter try with some wood in the bottom to prevent the paper sticking to the bottom, and lots of holes in the bottom, which I have used for the last 15 years or so, and when I have finished 2 prints I wash them for five minutes, then squgee them and hang them to dry,
Richard

andrew.roos
01-09-2013, 01:55 PM
The 15 minute max wet time is in the MG4 RC technical information sheet from Ilford. I was my prints individually for 2-3 minutes under fresh running water (using the shower attachment on the bath!).

pentaxuser
01-09-2013, 02:01 PM
On a B&W nightschool course I and the other 20 students did exactly as you do. We all used Ilford paper and none of us experienced any delamination issues. No, two hours is not ideal and if you can shorten the time then do so but unless we were all very lucky I'd be inclined to conclude that no harm may come from your current practice. Ilford paper is incredibly tough and well made


pentaxuser

Kycoo
01-10-2013, 11:28 AM
Thank you all for the responses. I will start washing individually, i.e., as soon as the print comes out of the fixer, to minimize wet time.