PDA

View Full Version : Nooby plate questions



EASmithV
02-19-2013, 03:19 PM
Hello all,

I amazed myself when i realized that I could actually resume my plate coating fun in my little bathroom blackroom, with a rigged up drying box.

Now I have some really stupid questions;

How do you plate guys (safely) store your plates? I'm only doing 4x5 dry plate, but I want to soon try 8x10 dry plate

What's an appropriate fixing time for liquid light? Is 5 minutes with strong fixer enough, with a perma wash and 5 minute rinse at the end? It certainly clears it, but the emulsion is thick, so IDK...

Also, I came across the phrase "Over-Cooking" liquid light... Is there a maximum temperature that should not be exceeded when doing this? I'm using some expired liquid light, and seem to be getting reduced speed and fog, but i'm not sure if that's age or over-cooking. When I put it in my really old Dektol 1:1, it flashes up a great looking neg, and then the fog sets in FAST. I don't pull it early, because what you see isn't what you get with red lights and dev by inspection i've noticed...

I just shot a plate, i'm gonna try rodinal 1:50 to see it that cuts down on the fog.

Thanks!

EASmithV
02-19-2013, 06:49 PM
Well, 600ml Rodinal 1:50 just started burning up the edges of the plate without developing the image. I added 100ml of old Dektol 1:1 and it saved the plate, but i tried another with 600ml rodinal 1:50 and 200ml Dektol, and that actually worked out quite nicely. much better contrast.

paul_c5x4
02-19-2013, 07:07 PM
Is there a maximum temperature that should not be exceeded when doing this?

I usually aim to melt at around 40-45C, but only a small quantity at a time. Using a plastic knife, slice, chop, and gouge lumps out of the original bottle and place in a small jar. Add an equal volume of water and melt. Repeated melting of the original bottle will (according to the instruction leaflet) will increase the fog levels, as will extended storage in poor conditions.

EASmithV
02-19-2013, 07:12 PM
Wait, so you are diluting your emulsion with water before coating?

paul_c5x4
02-19-2013, 07:27 PM
Yes. I also add a drop or two of alcohol at times in an attempt to reduce bubbles. Quite often, I'll do a second coating of emulsion once the first has dried.