I rewired my older Seal heat press because the old cloth-bound wiring was looking a bit ragged. I used a new grounded power cord and the wiring is correct, but I didn't pay enough attention to the position of the thermostat... I measured the lowest setting & it is running at 300 degrees! Anybody know how to reset that?

TIA!

No, but Seal became part of Hunt then part of Elmer's Products. Both Hunt and Elmer's still exist separately so don't make any assumptions about numbers when you start finding them.

They have a tech support line. I have no idea where the number is right now -I usually have to dig to find it.

Murray

Hi, if you mean how to set the knob, I would take the knob off. Then turn the shaft all the way towards the highest setting. Then put the knob back on with the mark pointing to the highest setting.

Jon

Jon- Thanks for the info... I got it (Cecil) back working.

We call it Cecil, because it looks like Cecil The Sea Serpent when its lights are on & its mouth is open!