Jobo CPE2 and 2800 print drum

[sandholm]

Hi,

Very simple question, i just got an lift to a CPE2, and I wounder if i can use the cog lid with a 2800 print drum, and use the lift while processing prints.

I checked the Jobo homepage, but didn't find anything about fitting a cog wheel to the 2800 series.

cheers

[Soeren]

Im not sure I understand your question but yes cog lids can be used with the 28000series drums. I you have a 2500 series drum with a cog lid just use that lid. the 2500 and 2800 series are, except for the funnel/cup and centerpost, the same.
Best regards

[sandholm]

Hej Soeren

That was my question, perfect, I tried the lib and it fitted but I wanted just to make sure
(ilfochrome is to expensive to screw up... ;)

thanks