PDA

View Full Version : PHSC Swap Meet: "The Big One" Returns Oct. 2 2011



CGW
09-01-2011, 01:43 PM
Only a month away!

So little time, so much stuff to buy...

http://phsc.ca/camera/?page_id=396

Hoping to find some deals on film and basic b&w processing gear. You?

Axle
09-01-2011, 07:36 PM
I would love to go...but I have a wedding that day.

Mike Wilde
09-02-2011, 07:31 AM
I got my form from PHSC asking if I wanted to rent a table. I think I will wait until the spring one to be a vendor again.

In the fall I always have a surplus of negatives taken over the spring and summer awaiting a serious printing session.
The cooler weather and fall rains seems to allow darkroom sessions to happen more readily than nice summer nights do.

So my backlog of work to be printed, sorted, matted, mounted, etc. overwhelms the urge to buy and sell more gear for the fall show.

JohnMeadows
09-02-2011, 07:52 AM
I certainly hope to go this time around! (Although probably the most dangerous thing I could do ....) :-)

Len Middleton
09-02-2011, 09:24 AM
I will be in Calgary that weekend, so will obviously miss it.

Still no response from the Calgary LF group about anything going on that weekend.

naeroscatu
09-02-2011, 01:27 PM
I have so much stuff that I'm ashamed to think of going because if I do I will probably end up buying again. Nice to own stuff but is so bad when you have no time to use it:(
I'm actually considering getting a table on the spring show and start getting rid of excess equipment and accessories.

Len Middleton
09-03-2011, 05:08 AM
I have so much stuff that I'm ashamed to think of going because if I do I will probably end up buying again. Nice to own stuff but is so bad when you have no time to use it:(
I'm actually considering getting a table on the spring show and start getting rid of excess equipment and accessories.

I did that for a while.

Found I did get rid of a lot of gear, but seemed like I did not make any money, as I spent it getting better gear... :D

Uncle Bill
09-03-2011, 05:05 PM
I'm double booked that day with another event.

Plate Voltage
09-03-2011, 06:45 PM
I might go and look for some medium format equipment if work doesn't get in the way...