Please help me pin down this problem
Have a look at these three prints, the top one printed last week (not so saturated in real life), the bottom two last night:
The first two have the same settings (105M / 95Y, 7 seconds)
The bottom one is 60M / 50Y, 7 seconds
Why are the first two strikingly different?
After I made the first print I removed my lamp and put it back in (see this thread for why) - both prints use the same lamp. My Blix was new and my dev had been replenished. Paper is Endura and chemistry is Kodak replenisher.
After printing the second one I attempted to filter out the cast, not a bad attempt for a guess under artificial light. But what's going on here? The whites on the borders of the second two are also a little yellow - like the difference between milk and cream.
Something disturbed inside the enlarger?