Effects of water drops over undeveloped film
Until now I always gave for granted that in order to develop a film all the tank elements (the tank itself, the reel(s), the funnel) had to be perfectly dry before loading the film.
This prevented me from executing a second batch of film immediately after the first one because I use a Jobo CPP-2 with "lift" and presently I only have one cog lid. After the first batch I always wash the tank and wait for the day after to process the second batch.
It was my understanding that water drops on film before pouring the developer would have caused a visible mark.
Recently I begun pre-washing film. You have already guessed the question, but I will state it explicitly:
Do I really have to wait for the tank to be perfectly dry before loading it? I understand that some drops of water might fall along the funnel of the lid and reach the film, but is this really so important considering that within a few minutes I'll be pre-washing the entire film in any case?
I would be glad if you could just dry the tank, use dry reels (I have several of them), dry the lid where I can, don't worry about drying the inner light trap of the funnel and immediately begin the second batch.
Thanks for the advice