the answer is right there:
page 5 of this PDF:
Table 4: Preparing Tank Solutions from Replenisher Solution
go to the section of c-41
to make one litre:
start with 860ml dev replenisher add 126ml water and 14ml dev starter. total 1L
these amounts are stupidly uneven and hard to measure with proper accuracy, but like i said in the PM, starter is not that crucial, and if you round up everything to the next decimal value (130+20ml) you will be 100% fine.
As mentioned elsewhere, you don't really need a starter. Starters are more for labs who want consistent results run to run, the starter makes it less fresh, more replenished performance so that a fresh batch isn't different than a batch once you get things going. For home use you don't really need to worry, you can correct for any minor differences from sheet to sheet when printing.