Yes, it really is that simple.
IMPORTANT: It's *not* just a file...you need to get sandpaper (for metal) to completely smooth out every part of the carrier -- both plates, both sides. Otherwise, obviously, you'll scratch and ruin all your negs.
Just use the 35mm neg in the middle of a glass 6x6 carrier with the masking strips closed down. No filing required, and no problem with un-flat, poorly supported negs.
No. I was given a few but never used them. My photographs stand on their own. If I need a black boarder I use a black mat.
Personally I'd say that Black and White prints are even more 'dated' and more easily imitated in photoslop. Therefore it would be prudent to give up on B&W photography...
It doesn't have to be a sloppy edge, as some have mentioned. If you do file a carrier out don't forget to paint the edges.
To clarify my comment on photoshop. It was ONLY to refute the comment that the presence of a carrier edge PROVES that the print was made from film. My argument was that the same effect can be applied to a digital image and therefore negates the quoted statement. In other words a digital image can be made to LOOk as if it was a film image. Nothing else should be inferred from my statement.Quote:
Inclusion of the negative carrier edge in your print also identifies the print as a projection print made from film.
I make rough black borders without involving modification of the carrier. I work out the image size( normally constant for several prints), and then produce a black card mask with the border cut into it. This sits in the easel on top of the paper which is then exposed to make the border, card removed, then image exposed. When preparing the mask, I cut one side, then cover the cut on front and rear with transparent tape. Doing this one side at a time keeps the image area mask suspended within the outer frame. Depending on how you set up the image size, you may need to print the border with the easel frame raised. The whole process is easy to do. The important part is keeping paper and mask aligned in the easel. I wouldn't recommend this for producing fine black borders! Alex
It just shows that the digi-snappers, in the words of Simon and Garfunkel,
Just like HDR, trying to be film but can't get it up!Quote:
I've just been fakin' it,
I'm not really makin' it.
when you look up in the sky
You can see the stars and still not see the light
I used a Dremel, then fine-tuned with a file (burnished the edges to finish off and avoid scratches). But before I had an extra 6x6 carrier, I just cut a neg carrier from black mat board that was slightly larger than the image.