Switch to English Language Passer en langue française Omschakelen naar Nederlandse Taal Wechseln Sie zu deutschen Sprache Passa alla lingua italiana
Members: 70,476   Posts: 1,542,652   Online: 776
      
Results 1 to 2 of 2
  1. #1

    Join Date
    Aug 2004
    Location
    Northern suburb of Atlanta, GA USA
    Shooter
    4x5 Format
    Posts
    113
    Images
    1

    BTZS tube Developing Times

    I read some where, possibly here, that BTZS tubes shorten the time for developing compared to Trays. I thought I might make a tube and try it.

    1) Is there a rule of thumb for reducing the time in tubes? (assume PMK averages 12-14mins in tray, what is change in tube time?)

    2) What is amount of developer needed for 4x5? 1/2 tube, 3/4 tube? more less?

    3) Is contrast increased/decreased by the constant spinning in a waterbath?

    4) Would PMK require a change of developer midway due to oxidation? or would I just use more developer?

    thanks in advance!
    Eric
    www.esearing.com

  2. #2

    Join Date
    Dec 2002
    Shooter
    Large Format
    Posts
    6,242
    Quote Originally Posted by esearing
    I read some where, possibly here, that BTZS tubes shorten the time for developing compared to Trays. I thought I might make a tube and try it.

    1) Is there a rule of thumb for reducing the time in tubes? (assume PMK averages 12-14mins in tray, what is change in tube time?)

    2) What is amount of developer needed for 4x5? 1/2 tube, 3/4 tube? more less?

    3) Is contrast increased/decreased by the constant spinning in a waterbath?

    4) Would PMK require a change of developer midway due to oxidation? or would I just use more developer?

    thanks in advance!
    1. I believe that typically the tray times are extended by 10-15% over rotary processing times.

    2. That would depend on the volume of developer to square inches of film. I don't use PMK so you will need to determine that based upon PMK recommendations.

    3. Contrast of a given film (within the limitations of the emulsion) is increased by increases in any of the following individually or collectively...

    a. strength of dilution

    b. time

    c. temperature

    d. agitation

    4. PMK has not been generally recognized as a developer for rotary processing. At least that is my information. There have been some changes in recommended procedures with this developer. This may be one of them. Best to check further.

    Good luck



 

APUG PARTNERS EQUALLY FUNDING OUR COMMUNITY:



Contact Us  |  Support Us!  |  Advertise  |  Site Terms  |  Archive  —   Search  |  Mobile Device Access  |  RSS  |  Facebook  |  Linkedin