I'm new to the Pyrocat HD developer and I have a simple question:
your experiences (times, results) about the following films:
Efke Pl 100
Fortepan 200 and 400
sheets and roll film developed in trays and small tanks.
I usually print by contact or small enlargements on silver paper.
Most of the informations I found are for Jobo rotary or BTZS tubes, very few of trays and small tanks.
Thank to Mr. S. King for his formula
Ant suggestion is welcome
My first suggestion would be to check out this webpage:
Sandy has compiled a wonderful article on Ed's site and most of the info you've asked is contained therein. Most of those whom I know use pyrocat HD use it for sheet film, but there are a few of us that use it for roll film and it's great. I've personally standardized on it.
Let's see what I've got in the magic trash can for Mateo!
I recently started using Pyrocat-HD for tray processing 8x10 sheets.
I have used Fortepan 200 and Hp5 plus rated at EI:100 and 200 respectively. I find that I prefer to process no more than 4 sheets at a time in a 11x14 tray. After a 2 minute presoak I process @ 20 degrees and agitate 1 sheet every 15 seconds by moving it from the bottom to the top of the stack. I gently rock the tray between each agitation.
Fortepan 200 stains better and looks a little richer in a print than Hp5 plus
I particularly like the way it looks for portraits. I would use around 16 minutes as a starting point for either film in this developer.
I am yet to try Fortepan 400 in Pyrocat-HD (only Rodinal), it doesn't have the same thick emulsion as the 200 film and it has noticable grain if you are enlarging more than 3 times. Perhaps the pyrocat stain will help in this respect by masking the grain. The 400 certainly produces a nice tonality in contact prints.
In medium format you should get a nice 10x10" print with minimal grain from Fortepan 200 in Pyrocat HD.
Hope this helps
your indications are interesting.
I will test the Fortepan 200 and HP5 sheets with your starting point and then I will post the results.
For this purpose I had made some sheets at the speed you indicate, even if I saw that you can use the film at the nominal speed.