WTB: Unicolor, ... etc. roller base

[Usagi]

I am looking for a simple roller base for table top rotary processing.
The roller must be compatible with 220V/50Hz.

[bushpig]

I hope you find it.

Check eBay. I just got one from there. If all else fails, you can just roll your drum by hand on a table or countertop.

[Usagi]

Not very easy to find. I have seen only couple, all listed in US ebay, thus requiring 220V/110V converter.

So I am still looking for. Anything that can handle Jobo 3010. Simma, Beseler, Durst, ...

[Greg Davis]

Don't get a Chromega. They work just fine, but not with the Jobo drums. They only run in one direction but use a side to side wobble that makes the drum walk off the end.

[bushpig]

Not very easy to find. I have seen only couple, all listed in US ebay, thus requiring 220V/110V converter.

My bad. I didn't realize where you were located.

Good luck.