8x10 to 4x5 Reducing Back, for Graphic or Graflock Back
$80 or best reasonable offer

This is a nice wooden reducing back for an unknown 8x10. The raised part where the reducing back mounts is shaped just right for a Graphic or Graflock back from a Speed or Crown Graphic (not included), with strips of velvet glued in place and mounting holes drilled.

11-1/2" square with mounting pins 5/8" in from each corner. A good sturdy piece of woodworking. Finish is in nice shape. Scratches, a few gouges around the rear perimeter but nothing serious. A good serviceable piece of equipment.

It's a bit dirty, tarnished, used, but it'll work.

The back weighs about 1 lb 4 oz. so figure about 2 lbs 4 oz. shipping weight from 90027.

Please Note: I wait for Paypal to clear to my bank account before shipping; this takes about 3-4 days.

Here's the picture: