Switch to English Language Passer en langue française Omschakelen naar Nederlandse Taal Wechseln Sie zu deutschen Sprache Passa alla lingua italiana
Members: 69,875   Posts: 1,520,207   Online: 1244
      
Results 1 to 4 of 4
  1. #1
    Loose Gravel's Avatar
    Join Date
    Feb 2003
    Location
    Santa Barbara, CA
    Posts
    921
    Images
    14
    I have two of these things, one 1969 and one earlier. The motors are not that strong. The '69 has that 'smell' (like it is working hard) and from the original owner I understand it has always had that smell. I have never seen one that didn't struggle. The spring is balanced, i.e. it is the same up as down (pretty much).

    Any tips? Is there some place that needs oil or grease or are they all underpowered?

    Thanks.

  2. #2

    Join Date
    Dec 2002
    Shooter
    Large Format
    Posts
    6,242
    I have been delaying reply hoping that someone who had experience with this enlarger might respond. I don't have direct knowledge with this enlarger. I do, however, have extensive experience with motors in general. What I would do, if I were you, would be:

    1. Disconnect electrical power to the enlarger. Next I would remove the mechanical connection of the motor from the enlarger chassis to make sure that you don't have some type of mechanical bind or drag in the chassis itself. Any mechanical drag will overload the motor and cause it to smell. What you are smelling is the varnish of the windings burning off because of overheating.

    2. Since the motor is disconnected from the enlarger chassis at this point, I would next make sure that the motor shaft spun freely. If it did not then I would apply penetrating lube such as Triflo (first choice) or WD 40 to the motor shaft to attempt to get lubrication into the bearings. If this did not free the motor I would then remove the through bolts and disassemble the motor. It will be in four pieces those being two end bells, the stator, and the rotor. You should be able to lube the bearings that the rotor shaft ride on at this point.

    3. If the motor is a brush type motor (rotor will have copper windings if it is) clean the commuter (portion that the motor brushes ride on) on the rotor with crocus paper. It should have a nice copper appearance when finished.

    4. If it is a brush type motor, check the brushes for wear. These will be romovable externally. Normally the brush holders will be of bakelite construction and be removable from the external side of the stator (the part with copper windings) that the rotor (the part with the external shaft) runs inside of. If the brushes are excessively worn, you may find these at a motor repair station.

    5. Reassemble and it should be good to go if no damage has been done to this point.

    Good luck.

  3. #3
    lee
    lee is offline
    lee's Avatar
    Join Date
    Nov 2002
    Location
    Fort Worth TX
    Shooter
    8x10 Format
    Posts
    2,913
    Images
    8
    nearly everyone of the enlargers I have ever used had that smell. I have never heard of the motor going bad. That doesn't mean it won't or can't happen. It means in my experience, it has not happened.

    lee\c

  4. #4

    Join Date
    Feb 2003
    Location
    Louisville, Colorado
    Posts
    45
    My enlarger is mid 70,s and the motor smells a bit too. Dont worry about it though. Ken



 

APUG PARTNERS EQUALLY FUNDING OUR COMMUNITY:



Contact Us  |  Support Us!  |  Advertise  |  Site Terms  |  Archive  —   Search  |  Mobile Device Access  |  RSS  |  Facebook  |  Linkedin