coating methods for paper and ceramic tiles, first results
this is my first one in this forum, but i think i will like it here.
after my first few attempts with liquid emulsions on vat boards and ceramic tiles some questions are rising up for me. Although i know that this way of making a print gives you non repeatable results most of the time, i would like to try to understand how all the factors work together. I feel there are lots of interesting possibilies in this photographic process with liquid emulsion.
for instance: the coating technique for the synthetic resin paint i use for the ceramic tiles ( i used a 4cm brush for a 20x20cm tile) seems to influence how the emulsion spreads on the surface. the effect is somewhat trashy but nevertheless really interesting since it adds feeling to the picture. i also have different results from coating the tile with the emulsion if i either use a brush or a rubber roller (for woodcuts normally). most strangely, i have produced distinctive areas in the picture that are unsharp but which should normally render sharp in the print. i still have not figuered out yet if this is a matter of the paint or of the emulsion.
i will post some samples in the next days so my words will make more sense.
my question is: how do you coat your ceramics, (eg. brush, spray paint, dipping etc.) and what do you use to apply emulsion to the surface and how much of that white pudding is on your photographs.
i use "lighthouse" emulsion with tetenal dokumol 1+9
here is a repro of one 20x20cm tile:
how long do you develope and fix your image? do you use a stopping bath with acid or just water?
cheers, and a good weekend!