Here's a much better example of a home made 95 mm filter adapter...
Uses Calumet 4x4 resin filter mounts:
Bore a 100 mm (3-15/16") diameter hole in a 4-1/2 x 5-1/4" piece of 1/4" plywood. The hole should be just a bit smaller than the lens O.D.
Glue some wood rails on both edges.
Saw a slot thru to the hole for a "springy" fit onto your lens.
Clean up an polish to your pleasure.
The basic idea can be applied to front or rear lens filters.
Been makin' 'em for years.
Last edited by Reinhold; 12-18-2010 at 08:15 PM. Click to view previous post history.
Reason: better photo's