Hello, I have a Durst 3 bath Roller Processor, and I intend to work with it to make Ilfochrome prints. My questions are this:

- last time I made Ilfochrome it was difficult to wash as I needed to wash them several times before getting the bad smell out of them, how can I avoid this?
- Getting this Ilfochorme prints dry was a trouble. What should I do to get them dry fast and for them to end up really flat?
- I use a gas mask in my darkroom, but this chemicals smell too bad. Is that normal?
- Whitout the water bath that it says I have to give after the second bath, as my Processor has only three baths will I be able to make the prints?

Thank you:-)