Quote Originally Posted by bdial View Post
If you get consistantly good exposures metering with the Gossen and the various cameras, then there may be a problem somewhere in your technique, although what you describe seems ok.
With the Gossen, how close are you to the grey card? If I were doing that test I'd be no more than 3 or 4 inches, FWIW.
Yes, about 3 or 4 inches but the reading stays consistent to about 12 inches.

Quote Originally Posted by bdial View Post
What happens if you make a reflected reading with the Gossen, then rotate 180 and make a reading with the incident dome? The two should match.
Spot on.

Quote Originally Posted by bdial View Post
Also, with the cameras, are you focusing on the card or working with the lenses set to infinity? Setting them to infinity would be preferable.
Focused on the card, more or less.

Quote Originally Posted by bdial View Post
Finally, if you scan around metering various portions of the card, do you get any difference in the readings with any one of the meters? I.E. are you getting any bright areas of light on the card that may not be easily visible?
It appears very flat from edge to edge.

I'm becoming just a little suspicious of my meters, even though my little Gossen Digisix is new, I'll compare it again to a friends Minolta, perhaps send some stuff out for a check up.