Quote Originally Posted by Rom View Post
Dear all,

Trust you are well.

I just finished to develop one roll exposed through my OM10. I just noticed that near the 2/3 of the film, i have a light leak which has burnt the film from the edge to the center.

How can it be possible ? If the back of my OM10 was not light proof, i am supposed to have the leak on the whole film, isn't it ? The burn is just on 3 to 4 cm large.

Do you have any though about this issue ?

Thanks in advance
light leak is where the back hinges. When the film is wind in it only expose a strip vertically. The film is wound on the roll and the side that face the camera won't get burnt. I have this on my Minolta XD-11 and only when it's very bright outside. I replaced the foam and it's ok.