My preference is to use an alkaline fixer like TF-4 that doesn't require a hypo clear. So it's 1 minute in Fix#1, 1 minute in Fix #2, a couple minutes wash in running water, then into a standing water tray until the end of the printing session. When the session is over, all the prints that have accumulated in the tray get either a 30 minute wash in running water, or 6 half-hour soaks in standing water.
Interesting! I have used TF-4 with Pyrocat HD for some time; I will have to try this method once I burn through all of my sodium thiosulfate.