Quote Originally Posted by mindthemix View Post
Based on some posts, the glue used by Yashica at that time was not good and after the years dried the logos comes off.
Does anybody knows how to remove the logos without scratching the camera or braking the plastic plates?
I want to re-glue them as a precaution.
Thanks,
Federico
I suggest doing two things. Both assume the plate is secured poorly by old glue.

(1) Push the edge of the nameplate sideways with your thumbnail. This might put enough pressure to break the glue-bond.
(2) Pull off the plate using duct tape or some other strong tape. The old glue is weak, so a fairly strong pull from attached tape might remove the plate.

Good luck,

Mark Overton