No, I didn't check that. Will that cause a problem, if the reel top and bottom aren't aligned after I finish loading the film?

Did I buckle the film during loading?

I know that I had to fight with one reel to get the film loaded, so I switched reels. The film loaded fine. Then back to the first reel, and loaded it with a new film, and went fine.

But both films showed buckles.

Not likely I'll chance using either reel again, but would be nice to know what happened.

...Vick


Quote Originally Posted by bobwysiwyg View Post
You probably did this, but it 's worth noting, the two starting points on the reels "must" be adjacent to one another. Even if off slightly, you 're going to have problems.