After checking my negative notes for the prints i just did they were done at:

TMAX 100 in Ilfosol 3 for 5:30 (Inverting the tank four times during the first 10 seconds, then 4 inversions during the first 10 seconds of each subsequent minute)
Neopan 400 in HC-110 (B) for 5:00 (Agitating 5 seconds every 30 seconds)

I measured the temperature to 20 degrees for everything but the final wash. Does the final wash temperature matter?

The negatives themselves look fine exposure wise, the meter on the F80 is pretty good. The prints are not being cropped, i'm printing so the whole negative shows on the print.

Thanks