Quote Originally Posted by Bob Carnie View Post
I am really interested in how you are going to make these monster prints in a single tray.
I may be fooling myself about that but I hope I can make it work. The tray would be on a tilt-table with very large/fast fill and dump valves with hoses... at least an inch in diameter. Chemicals would be on heavy-duty selves above the tray. Dumping would occur via a huge valve at the far end of the tray in a shallow sump area with a V-shaped wedge to help facilitate gathering of fluids at the dump valve. Chemicals will be saved in buckets to reuse. Rinse and wash water will go to the septic tank. Processing time will be fairly long to avoid unevenness and streaking. I'm thinking stainless steel is a must if I use the same tray for all chemicals.