4 ft square it pretty tight.
But if you don't have space/facilities, you make do with what you have.
I figure 2ft for you to work/stand in, and 2ft for the table ( or 1.5 and 2.5 if you are thin). Thus Your table is either 2 (or 2.5) ft deep x 4ft wide.
If you need 2ft width for the enlarger, timer, etc, then you have only 2ft left for the wet side.
If you use trays, it would have to be 5x7 trays. Or use stacked trays.
Better would be to use a vertical slot processor or a small drum processor.
And wet and dry will be side by side, so no splashing.
Last edited by ac12; 03-11-2013 at 06:11 PM. Click to view previous post history.