Sorry for highjacking. But I'm sure I'm not the only one here completely loving your setup, who would like to do their own.
I see relay outputs of the PIDs but they do not specifically state that they are solid state. Some show voltage and amp, some just say relay. So that must be what you were talking about with the internal relay. Seem to only be able to handle 750w and under at 110 with the built in ones.
So, I can run a 4000w / 220V element (which would require a 30amp circuit), at 110V / 1000W (halve voltage, gives you quarter wattage) from what I understand.
So it will run on a 15amp circuit, and take 9amps to run. I think I should run 14 guage to stick with code.
Last edited by WayneStevenson; 03-12-2013 at 06:53 PM. Click to view previous post history.