My print was slightly damp in a couple places when I put between my regular two pieces of mat board, in the dry-mount press. I've done this before and it usually just turns to steam, but this time the print stuck to the mat board. It came off easily enough but left black (the mat board is black) smudges at three contact points on my print.
Am I SOL?
Anybody know of something that will clean the print?
Not the end of the world but I kind of liked the way the print turned out...
Putting wet prints against mat board, or any other absorbent paper other than photo blotter, is a big mistake as you have learned. Always use release paper with dry mount press.
[FONT=Comic Sans MS]Films NOT Dead - Just getting fixed![/FONT]