Quote Originally Posted by greybeard View Post
A standard technique for positioning countertop laminate ("Formica") is to put contact cement on both surfaces, let dry completely, and then place a sheet of kraft wrapping paper on the base. Ideally, the paper will cover all but a fraction of an inch at the most critical edge or corner. The laminate is placed on top, and positioned carefully. (The small amount of adhesive that bonds is weak enough to be error correction.) Then the kraft paper is pulled out, and the bond made progressively from one side to the other to prevent bubbles.

It think that for something as small as a tripod top, I would use waxed paper or even silicone release paper to do essentially the same thing.
Actually, the technique I was taught for countertops (Dad was in the trades) was narrow strips of wood or scrap from the Formica. Using that model, I think flat toothpicks might be the way to go for such a small job. (Release paper actually sounds like a good idea!)

I am now in possession of both unadhesived cork (and glue) and the self-adhesive kind. I am going to experiment and will get back to this thread with the results.