Hi guys,

I recently acquired my first enlarger: an Omega D5XL (old grey version) with Super Chromega D Dichroic II. It's a big monster to make my first step in printing. But some screws are rusty and limp and I would like to replace them. Unfortunately I live in France and the imperial units aren't standard. Can anyone inform me about the model/size of the two followings screws I need to remove:
  • the upper and lower rear hex screws around the elevation knob (and the same on the other side of the rear carriage axle; those ones help to adjust front/back alignment);
  • the 4 phillips screws around the negative stage (used for the negative carrier/lens parallel adjustment).