I've never done this myself, but if you did a sufficient rinse/wash after dunking it in the stop, it should have rinsed out most of the acid/developing stopping gremlins. Matt is right though, if you have a developer available with a longer dev time, something like 10-15 minutes, that will give you some peace of mind. Definitely make sure you give the film a good pre-wet, (fill and agitate the tank for 20 seconds, dump) make sure you do this at least 3 times to really give the film a good clean start.

At the very least you will get something so just go about business as usual after the pre-wet and you'll more likely than not be completely fine.

That said, I would be very careful with your chem temperatures, the wet/drying cycle may have made the emulsion more brittle/fragile than usual, and you don't want to risk reticulating your film.