Quote Originally Posted by Thomas Bertilsson View Post
Hi Ned,

If I print as much as 30 8x10 equivalent, there is always room for the 300 ml.
Usually I don't print that much so for the most part I just end up topping up my gallon of working solution. There is a fair bit more chemical transfer than most people think.

It's a very nice and economical way to print.
Thank you very much. I misunderstood: I was thinking that you were supposed to wait until printing that much to replenish. My printing sessions rarely use more than 2 or 3 8x10 equivalents!

Sounds like this will work:

1) top off the working solution after each session
2) keep an eye on it, and make sure at least 300ml of replenishment has happened for each 30 8x10 prints.

Ned