My dry mount press has decided to be very bad. I just wanted to flatten some fiber prints today so I fired it up. Seems that maybe the thermostat has given up the ghost. The temp selector knob was in its normal place and I thought every thing was fine. I put the print in and lowered the platen down and within a minute burned the print to a crispy critter. Now I restarted the press and the thermometer showed 350F It was set at 225F. Huge difference. Is my thermostat blown and if so, does anyone know where I can get a new one. It also toasted the fabric on the cushion underneath. I am really bummed because I take excellent care of my equipment and now this. Any suggestions would be more than welcome. Thanks, Don