Hm, thanks guys !
I have two "probes". But it doesnt say CPE2 plus on the front like I have seen on others. CatLABS do you know which is the temp sensor, or know where the temp sesnor ends up on the "main-board" so I can follow it ? If it's broken beyond repair, how much is it for a spare, if you want me to contact you, is this place to do so : http://www.catlabs.info/contact ? Thanks again ! =)
One of the wires seems to end up at the potentiometer for controllig the temp, and the other wire ends up at the silver/shiny box that contains the "thermal overload protection" switch if this can help in locating which is the temp sensor. Both wires "SEEMS" to be okay, but I dont have my meter with me here so I cant check for sure right now.
After reading CatLABS post a bit closer, it seems that if one of the wires is for the fuse for the heater protection, than the other wire that not ends up at the heat overload switch is probably the temp sensor, might I be right in that ? :P
Last edited by taulen; 11-04-2013 at 07:29 PM. Click to view previous post history.