I've been looking at what chemicals I need to make my own developer, stop, fix, and hypo-clear and I've come up with these:

Hypo Clearing Agent
Water (125 F) . . . . . . . . . . . . . . . . . . . 750 ml
Sodium Sulfite . . . . . . . . . . . . . . . . . . . 200 g
Sodium bisulfite . . . . . . . . . . . . . . . . . . . . 2 g
Water to make . . . . . . . . . . . . . . . . . . . . . 1 liter

Dilute 1:9 for use.


Pyrocat-HD
Stock Solution A
Distilled Water (125 degrees F) . . . . . . . . 75 ml
Sodium Bisulfite . . . . . . . . . . . . . . . . . . . . . 1 g
Pyrocatechin . . . . . . . . . . . . . . . . . . . . . . . 5 g
Phenidone . . . . . . . . . . . . . . . . . . . . . . 0.2 g
Potassium Bromide . . . . . . . . . . . . . . . . 0.2 g
Water to make . . . . . . . . . . . . . . . . . . . 100 ml

Stock Solution B
Distilled Water . . . . . . . . . . . . . . . . . . . . 100 ml
Potassium Carbonate . . . . . . . . . . . . . . 100 g

To make a standard working solution, mix 1 part A with 1 part B with 100 ml water.

TF-2 Alkaline Fixer
Water.........................................1000 ml
Sodium Thiosulfate................250 g
Sodium Sulfite (anhy)............15 g
Sodium Metaborate................10 g
Water to make...........................1000 ml
Fix the film for three times the clearing time, usually 3 to 5 minutes. Follow with a two minute wash in running water for film. A hypo clearing agent is not required. Prints should be rinsed for at least 30 minutes in running water.


Stop Bath
A small spoonful of ctirc acid in a liter of water


This is what I've been able to gather from personal emails, these forums, and various websites. Any suggestions or corrections?
Also, will the hypo clear not be needed due to using the TF-2 fixer or does it still reduce the wash times?

Jeremy