Today I decided to give dry mounting a try but the kicker is a dry mount press is out of my budget. I heard about some people using a household iron as a substitute so I decided to give it a try. The results were pretty bad. I set the iron on high heat (no steam) and tacked the corners to the dry-mount adhesive. Then I laid the print + adhesive down on the board and proceeded to press it out. These were 11x14 prints so I found that as I pressed out one side and moved up the print, the side I had just done cooled off and the print started to detach from the adhesive. I then placed weights on the whole thing and found that some areas remained attached while other areas of the print were not properly secured and peeled off right away. Any tips from those of you who dry-mount your prints without a dry-mount press?