Quote Originally Posted by Michael Slade
Printing today on the 'smooth' side of the Platine. First print out and it looks very nice. Perhaps slightly more resolution on the smooth side rather than the textured.

Also noticed less bronzing. Two reasons for this maybe. Today I'm using 3.5 ml of solution, yesterday was 4 ml. Today I'm allowing them to air dry w/no heat...yesterday's were force dried. Single coating on both yesterday and today.

I think I'll play with double coating tomorrow...
Double coat always with VDB. Let the first coat dry before applying the second. I'm not sure of your negative size but for 7x17 3,5 ml sounds okay. Too much solution and over exposure can cause bronzing. Are you printing a step wedge too?

Don Bryant