It was back in the late '70 when I finished my first University degree, a multi major one. Graphic Design, Photography, Printing and Publishing. I applied and was accepted to Art Center College of Design in Pasadena, CA which was the best Art school in the World at the time. I had two degrees when I went there and was a combat veteran of the Vietnam war. What I experienced was "Conceptual Photography". Don't buy any equipment until you have a specific use for it. Don't buy any film until you know what you will shoot with it. Don't go out and shoot until you have a complete idea of what you will be imaging. Don't print until the negative has been inspected and checked off by a lab assistant. Don't wash the print until it has been checked off. Don't just take your print out of the wash, you must take all of the ones there at the same time, you name it you claim it. If someone beats you to it and your print is damaged, too bad start over and next time be there to take the print out first. Don't mount it until the print is approved to be mounted. Take it to class, on time or it's trash. The instructor then flips the board to see if the print pops off. If it does, your screwed. If it doesn't you may get a chance to be graded. This is not a joke either. Check the tuition and take a visit and you will see.
I dunno, sounds like a rigourous training program to me. As a formar military, you must have been accustomed to discipline, no? - Perhaps the most serious objection I would have, is against the 'don't buy equipment until you have a specific use for it' - I would have failed miserably on that account - lemme count, over 50 cameras....and still trying to figure out what specific use to put them too...