Dumb question of the day: I developed some 8x10 PL100 in Xtol1:1 and even going up to 15 minutes in a tray at 73 degrees I am no where near where I need to be as far as density on the negatives. Xtol was freshly made. This is for platinum printing. I used ASA 100. Should I have reduced the ASA? I've done it with Trix and this combo with no problem and used ASA 300. I ended up using this because I wasn't sure my Pyrocat was good
Besides with the Na2 method my densitometer won't read pyro negs and this method goes by the numbers. I'm stumped...
Peter