Hi Murray,

Yes, I mainly use Color Mount. I bond it to the back of the print for about 30 seconds, although I don't think that this is too critical. The mounting tissue does bond completely to the back of the print. After the print/tissue is trimmed to size--which guarantees that the print and the tissue are exactly the same size, and that they are perfectly aligned--position the print on the mount board. Tack a small spot by putting your tacking iron on the front of the print, using a small piece of release paper between the print surface and the tacking iron. I always do this along either the top or bottom edge of the print, as Seal recommends. I haven't noticed any problems on the prints from doing this. Then into the press it goes.