When I used to go to the Saidye Bronfman darkroom in Montréal, they had a blow drier for prints. I used it on RC prints with decent success, barring the occasional water spot in the surface. I used FB a few times, and always printed it first, then blow-dry as much as I could, in the hopes that the paper would be sufficiently dry by the end of the evening when I left. It was never really satisfactory, and I put the photos between some sheets of drying paper. Bits always got stuck in the emulsion.

I would suggest trying to go the plastic / wax paper route instead. You want to avoid any drying to happen during transportation. Then, when you come home, you may re-wet your prints so that they dry evenly.